That’s when I discovered the blown fuse and replaced it five times, blowing each one immediately. I was so proud of my successful repair job (also replaced the gas lined that they chewed)! After plugging back into shore I noticed the Alde control panel was dark. I had just replaced the wiring going to the brakes because rodents had chewed them. Around the time it blew I went from shore power to TV power while the Alde was on. Reading this thread makes me wonder if the converter could be the culprit. But even if this fixes the problem I’m concerned by how it blew. A week has gone by sense diagnosis and still no part ordered. Ordering the part has been a nightmare because Alde rarely answers their phone. He’s not very familiar w Alde but after talking to one of their techs determined that the circuit board needs to be replaced ($320 part). Used to forced start burning outside the control panel. You can check the electrical in the Alde boiler works by, and buy a ndkabel to Alde 3010 to about. I tried the suggested trick of wiring the ground directly to the negative terminal on the battery to no avail. Is there still will not light in the control panel, it may be the large circuit board (PCB) located under the cover in the fired Alde. The 3.14 amp fuse on the Alde (the one in the green fuse holder going to the ground wire) keeps blowing.
0 Comments
Leave a Reply. |